RISTEC Design Philosophy



	*"The Rest of the Robot"*

All RISTEC products are designed to form a COMPACT seamless union with one another. You won't find a mess of adapters, wires, and hoses when you look at a RISTEC product grouping. Our products are designed with the intent of maintaining the "clean" look of the robots they are designed for. This is accomplished by running all of the utilities (pneumatics, electrical, etc.) on the inside of the units.

The image to the right shows the direct coupling of several RISTEC modules to the end of a robot quill and to each other. The gripper at the bottom of the coupled stack is then actuated without the use of external air lines.

Direct Coupling of RISTEC Modules

We sell "off the shelf" adaptor plates to mount our products to almost any robot in the industry. All you need to know is the Robot Manufacturer and Model you are using and we'll do the rest. Click the image below to enter the selection wizard.

If you are using an Adept™ robot, no adaptor plates are needed. All RISTEC products will mount DIRECTLY to the following Adept robots, providing quick and easy integration into your rapid deployment automation:

Direct Drive Robotic Systems	Table-Top Robotic Systems
Adept One	Adept Cobra 600 & 800
Adept Pack One	Adept 550 Table Top
Adept One-XL	Adept 550 Clean Room
Adept Three-XL	Adept Cartesian	RISTEC ToolChanger on Adept 550 Robot

For information on materials & processes used to make each module environment specific, see our environments page.

Home Products Environments News & Info Sales Support

Copyright © 2000 Robotic Interface Systems Technologies - Phone: 1-888-747-8322